HP Deskjet 2132 Printer [Setup Guide]

How to setup hp deskjet 2132 printer

HP Deskjet 2132 all-in-one printer is an excellent printing companion that provides faster and effective printing quality within a limited time frame. Moreover, it can be set up and installed easily and can be used with ease. 

For HP Deskjet 2132 driver setup, you need to unbox the printer by removing all package materials at first and then connect the power cord to the power source. After that, comes ink cartridges installation and paper loading within the input tray. To know more about it, read the setup guide mentioned below.

How to Setup HP Deskjet 2132 Driver?

For a brief knowledge regarding the setup for HP Deskjet 2132 printer, follow the steps given below in the same order.

Step 1: Empty the Printer

Start by unboxing the printer and excluding all tapes, stickers and other package materials one by one from the surface of the printer. Again, lower the output tray and then hold the handle situated inside the printer. 

Open it by lowering the ink cartridge access door. Eliminate all tape and the package materials within the printer. Close the access door. Note that all hardware and materials from the box should be discarded.

Step 2: Connect Power Cord and Turn the Printer On

Now, connect one end of the power cord with the printer and the other one into an electrical outlet. Turn on the printer by pressing the Power button.

Step 3: Install the Ink Cartridges

The next step involves ink cartridge installation. Hold the handle and open the ink cartridge door. Once the carriage proceeds to the middle of the printer, wait for it to get stable. Get rid of the ink cartridges from the packaging and make sure to touch the black plastic on the cartridge only.

Eliminate the plastic tape and hold the ink cartridges carefully from the sides. Now, insert the ink cartridges within the slot one by one. The black ink cartridge should be injected in the right slot and the tricolor one should be inserted within the left slot. 

Insert the new ink cartridges within the empty slot and push it gently until it clicks into its place precisely. To install other cartridges, follow the same procedure mentioned above. Shut the ink cartridge access door after installation. 

Step 4: Insert the Paper within Input Tray

Pull up the input tray and get rid of any paper within it (if any). Move the paper width guide to the extreme left and load a bunch of A4 size papers within the input tray. 

Note that the short edge should be first. Insert the stack within the tray once done. Again, push the paper width guide to the right side and pull out the output tray extender.

Step 5: Adjust Ink Cartridges

To get an efficient quality printing, one needs to adjust ink cartridges properly. Thus, after loading the paper within the printer, an alignment page will be printed. 

Now, raise the scanner lid and keep the alignment page in a position where the printing side should face the scanner glass. Make sure to place it precisely and according to the engraved guides of the glass. 

Once done, shut the lid of the scanner and then press the Start Copy Black/Start Copy Color button located within the Control panel of the printer. This will help the printer to align ink cartridges.

Step 6: Install Printer Software

This marks the end of your HP printer setup. Install the latest version of printing software by reaching the official website of HP. Make sure not to connect the printer to the computer until you are asked to do so within the printing software.

Hope that after performing the above steps correctly, you can set up your HP Deskjet 2132 printer without any hassle.

Leave a Reply

Your email address will not be published. Required fields are marked *

three + 6 =